Use for weld PVC, PE and other material can be hot melt, like flex,
PVC cloth etc.
► Before hemming or welding, leave 30-40mm wide overlap edge for
connection the two disjunct surface pieces, immobilize both ends of
each disjunct pieces with something such as stick belt or clamp.
► Turn on the power, according to quality and thickness of the PVC
banner, consider the ground circumstance, set the proper
termperature and speed, adjust the suitable hot-air blowing rate,
wait for machine hot up around 2 minutes.
► Bring up the machine, place the rubber wheel at the end of the
overlap edge.
► Turn the handle to left down, insert the welder nozzle into the
gap of two overlap pieces, then the machine will moving and seaming
automatic.
► During welding, use the long handle to align the moving direction,
let the upper piece edge be in touch with the inner side of the
welder nozzle.
► After the machine go pass the overlap edge to the end, the two
disjunct pieces will be joined together, then turn the welder
handle to right, it will stop moving.
► Turn off the heater switch, wait the gun come to cold, then turn
off the power supply is ok
4. Advantage :
• Use Leister heat resister, it is long life
• use hot air to melt the material and joint them together,no need
glue , Cost is very low
• Has laser positioning function , high quality
• With long handle, no need keep squat during welding , easy to
operation
• with sensor in the welder nozzle, can control the work temperature
accurately
• Work temperature,speed, and fan motor speed are adjustable , easy
to operation
5. Notice :
► To prolong the electrothermal heater, after work it is strongly
advice that cooling the heater at first, then turn off the power 5
minutes later. In case of the power suddenly be off, should handle
the welding gun away firstly, and close down the temperature knob,
nextly consider the problem of power supply.
► To get better satisfied bonding effect, the ground of the overlap
pieces should be smoothly, hard and heat resistive. We suggest that
the operator may do some more test and practice using some samples
of the pieces to get the suitable speed and temperature and hot-air
blowing rate before operate it for seaming formally
|
Thanks for your kind reading ! Any questions or demand contact me
freely : )
